It is hard to believe that many of my friends have been baffled by the start-up of vehicles. At the same time, they will find it very bothersome. Mixers should have this kind of situation. What should we do? Let's find the symptoms first, and then apply the medicine. The factors that cause the concrete mixer to start difficult are probably summed up the following points, are still in troubled card friends, may wish to check and check

搅拌车

1. When starting the concrete mixer truck, if only the sound from the electromagnetic switch of the starter is heard, the crankshaft does not rotate, which may be caused by the battery “breaking”. It is recommended to check the battery.

2. The self-discharge of the concrete mixer battery is serious, and the aging of the plates and separators will also cause short-term parking to start, but it will be more difficult to start again after a long period of parking. It is recommended to consider replacing the battery.

3, starter found that the starter suddenly turning powerless, accompanied by a burning rubber smell or smoke at the battery, then it may be extremely poor pile and pole clamp contact, resulting in heat burned.

4. When the starter starts, the drive gear and the flywheel ring gear of the Engine flywheel will make an impact sound, which may be caused by the deformation of the meshing cut-in surface of the flywheel ring gear of the concrete mixer wheel.

5. When the main power switch is turned on, the drive gear of the concrete mixer starter meshes with the flywheel ring gear. This may be because the starter solenoid switch's holding coil is wrongly connected to the power terminal or the key switch. The three lines on the wrong connection.

6. If there is only a slight "click" at start-up and there is no response afterwards, there may be a problem with starting the relay to issue a card.


Good Quality Cummins Natural Gas Generator Set,


Applied gas:

Natural Gas, Biogas, LPG, Landfill gas, Oil gas, Syngas, Coal mine gas

Acceptable fuel gas pressure: 5~12 kPa CH4 content: for natural gas ≥85% CH4 content:for biogas ≥55%

Gas heat value ≥5500 kcal/Nm3 (23MJ/Nm3 ). Genset output power will increase as the gas heat value increase, if use low heat value gas for fuel (Heat value< 5500 kcal/Nm3, it will lower the power efficiency.

Gas doesn`t include free water or free materials (the size of impurities should be less than 5μm.)

H2S content ≤200 mg/Nm3,NH3 content ≤20 mg/Nm3, Impurities content ≤30 mg/Nm3;size ≤5 μm,Water content ≤40 g/Nm3, no free water.

Standard Scope of Supply:

1. Brand new gas engine, 90% parts include engine body , crank shaft, cam shaft, piston, cylinder head, etc made by Cummins with best quality

2. Brand new brushless France Leroy Somer alternator

3. Rating: 3 phases 4 lines. 400/230V, 50 HZ , 1500rpm, 0.8PF, IP22-23, Insulation class H

4. Radiator for 40°C/50°C ambient temperature

5. Ignition system adopted USA ALTRONIC

6. Emergency stop mounted

7. Battery,Battery cable and Battery charger

8. Standard tool box

9. Standard Accessory for installation (include bellows,silencer,flange,asbestos pad,Anti-rust water,screw )

10. Gas Train include Regulator valve,Electromagnetic Valve, Fire arrestor,Ball Valve (Chinese brand)

Accessories list

1. Maintenance Operation manual

2. Quality certificate, Gen-sets ex-factory testing report

Optional:

1. Sound-proof canopy 2. CHP system 3. Grid parallel system 4. Remote radiator 5. Auto oil filling system 6. Water heater 7. Oil heater 8. Gas leaking detector 9. Flame detector 10. Gas scrubber

Natural Gas Generator

Natural Gas Power Generator, Portable Natural Gas Generator, Natural Gas Home Generators, Natural Gas Backup Generator

Weifang Huatian Diesel Engine Co., Ltd , https://www.enginepart.nl

Posted on